Level Fix clips 14-24 mm, joint width 2.0 mm

The clips are used in combination with a matching tensioning system. You place them under and between the tiles in the fresh tile adhesive, pull the tiles together and let everything cure. Afterwards you remove only the top part, leaving a smooth and flat tile surface.

Which tiles are these Level Fix clips suitable for?

The clips fit tiles with a thickness of 14 to 24 mm. If you have thinner tiles, this version is not the right choice. For thinner materials, up to approximately 12 mm, there is a separate variant with a smaller joint width. So always check the thickness of your tiles before you order, as the clips only work well within the stated range.

What should you look out for when choosing a joint width?

The joint width of 2.0 mm determines the distance between the tiles. That distance must suit the design, the tile size and the customer's wishes. With larger tiles, a wider joint is often more practical, because small differences in size are then less noticeable. If you prefer a different joint width, choose a clip with the matching size.

What is in the package and how do you use the clips?

This package contains 250 XL clips. The number you need depends on the surface area and the tile size, as one or more clips are usually needed per corner and per side of a tile. Allow a generous amount, so that you do not run out during the job. The clips are intended for single use in the joint, while the tensioning system can be reused.

Frequently asked questions

What tile thickness can I lay with these clips?

These Level-Fix 250 XL clips are intended for tiles from 14 to 24 mm thick.

What is the joint width with these clips?

The joint width is 2.0 mm.

How many clips are in a package?

There are 250 clips in a package.